You can make a difference in the Apple Support Community!
When you sign up with your Apple Account, you can provide valuable feedback to other community members by upvoting helpful replies and User Tips.
When you sign up with your Apple Account, you can provide valuable feedback to other community members by upvoting helpful replies and User Tips.
I had my old Android phone set up with my wireless printer. Got a. iPhone 14 and the printer was working but now has stop. When I try to print it says no air printer found. What do I need to do to fixed it?
iPhone 14, iOS 16
Hi,
Would it be correct to assume that your printer is a model supporting the AirPrint technology (About AirPrint - Apple Support)? If so, a special app from the printer manufacturer should not be needed for the iPhone.
The AirPrint-enabled printer must be connected to the same network (Wi-Fi router) as the iPhone. If the iPhone cannot properly detect the printer, you could try a full power-cycle sequence (do not forget the router): Power off the Wi-Fi router, the printer, the iPhone, and all other devices/computers. Wait two to three minutes. Power on the router. Wait two to three minutes. Power on the printer. Wait a minute or two. Power on the iPhone. Finally, power on all other devices/computers.
Hi,
Would it be correct to assume that your printer is a model supporting the AirPrint technology (About AirPrint - Apple Support)? If so, a special app from the printer manufacturer should not be needed for the iPhone.
The AirPrint-enabled printer must be connected to the same network (Wi-Fi router) as the iPhone. If the iPhone cannot properly detect the printer, you could try a full power-cycle sequence (do not forget the router): Power off the Wi-Fi router, the printer, the iPhone, and all other devices/computers. Wait two to three minutes. Power on the router. Wait two to three minutes. Power on the printer. Wait a minute or two. Power on the iPhone. Finally, power on all other devices/computers.
Can’t get my wireless printer to print with my new iPhone 14 was working but stop
