Vision Pro Windows are angled even after being "centered"

I noticed a dramatic skewing of all of my windows after installing my prescription lenses. I'm curious if others in this thread are using prescription lenses.

I have recalibrated and setup again. Also updated to visionOS 1.0.2, but still have this behavior.

Update: removed the lens from the device and paired them again. Issue persists. Left side of elements are tilted away from me slightly. It's as if the device is not recognizing I'm in the middle of the curved plane/track the windows move on.

I’m having the same issue! Super annoying and very distracting.

Organik ~ Let Apple know here:

Feedback - Apple Vision Pro - Apple

õ¿õ¬

The same here! My Zeiss lens profile is affected so, but my no lens insert profile is working fine.

Same issue. Very slight tilt to the left. Also have ZEISS lenses. Unfortunately my vision isn’t good enough to see anything without them so I couldn’t see if it happens without the inserts.

I tried a full reset, but it didn't fix it. I still have the problem. With or without inserts, the screen is skewed

So It’s been figured out for me. My issue was I was laying down with the Apple Vision Pro. The Apple Vision Pro is designed to automatically tilt the window in either way that it “thinks” is the best alignment for the way one’s head is tilted. Here is the solution Apple support, and I came up with.I .:grabbed the little bar on the bottom held it and-tilted my head either left or right to adjust the angle of the window. The downside is  I’m laying almost all the way down and I have to move my head to the right or left super deep. Remember, it’s not the “face” going from left to right but tilting the “head” left or right while looking straight at the window.

Update:

Tried updating to VisionOS 1.0.3.

The tilted window issue persists.

Same issue: windows seem like they’re “facing” slightly left of the center of my vision, very subtle but obnoxious. Just started doing this after a few days of using it. Not using any prescription lenses, just have soft contacts.

Thought I was the only one.

After installing my Zeiss inserts, all windows and even the home 'screen' of icons are all slightly angled away from me (left side is angled away). They are no longer perfectly parallel to my vision when viewing straight on. Very frustrating.

I've tried recalibrating the IPD and redoing the eye setup, no luck.

Haven't yet tried removing the lens inserts altogether and starting from scratch. Will report back.

I also had this issue earlier and I saw a post somewhere suggesting to enable travel mode and disable it with head still at center. It did improved quite a bit after I tried this but I can still feel it's not perfectly centered.

I'm experiencing this same thing. I've tried recentering with the crown, but I haven't redone setup to see if there is any change.

I have the same issue - thank god I’m not alone, very annoying.